JetLagPlanner

Flight time: Rome to Milan

Leonardo da Vinci–Fiumicino Airport (FCO) → Milan Malpensa Airport (MXP) · short haul · intra europe

The flight from Rome (FCO) to Milan (MXP) takes approximately 1h 11m to 1h 37m gate-to-gate, covering 511 km (318 mi). This short-haul intra europe route uses a cruise speed of 650–750 km/h with 30–50 minutes of ground and air overhead.

Estimated Gate-to-Gate Flight Time
1h 11m1h 37m
Distance: 511 km (318 mi) · short haul
Key Facts
Route:
Rome (FCO) → Milan (MXP)
Distance:
511 km (318 mi)
Flight time:
1h 11m to 1h 37m gate-to-gate
Route type:
short-haul, intra europe
Cruise speed:
650–750 km/h
Ground overhead:
30–50 minutes included
Over water:
No — continental
Origin:
Leonardo da Vinci–Fiumicino Airport, Italy (Europe/Rome)
Destination:
Milan Malpensa Airport, Italy (Europe/Rome)
Ad slot (top)

Route details

OriginRome, Italy (FCO)
DestinationMilan, Italy (MXP)
Distance511 km (318 mi)
Flight time (low)1h 11m
Flight time (high)1h 37m
Route typeshort-haul, intra europe
Cruise speed650–750 km/h
Ground overhead30–50 minutes
Over waterNo — continental routing
Time differenceSame time zone

Distance breakdown: Rome to Milan

The 511-km great-circle distance between Rome (41.80°N, 12.24°E) and Milan (45.63°N, 8.73°E) spans 3.8° of latitude and 3.5° of longitude, trending primarily west. In miles, this is 318 mi or 276 nautical miles. The great-circle path — the shortest distance over Earth's curved surface — is calculated using the Haversine formula from the two airports' precise coordinates.

Cruise speed and flight phases

Short-haul flights like Rome to Milan (511 km) spend a proportionally larger amount of time climbing to and descending from cruise altitude. Aircraft typically reach an effective cruise speed of 650–750 km/h, lower than on long-haul routes where most time is spent at optimal altitude. The climb phase alone takes 15–20 minutes, during which the aircraft covers only about 150–200 km. Combined with descent and approach, the effective average speed drops significantly from the theoretical cruise speed, yielding the 1h 11m to 1h 37m estimate for this route.

Ground time and routing overhead

Our 30–50 minutes overhead allowance covers: taxi-out at FCO, takeoff and initial climb, descent and approach at MXP, and taxi-in to the gate. FCO is a major international hub where taxi times of 15–25 minutes are common during peak periods. At MXP, arrival taxi and gate assignment can add 10–20 minutes, especially during busy arrival banks. Continental air traffic corridors between Rome and Milan may add 3–8% beyond the great-circle distance. Standard instrument departures and arrivals at both airports use predefined routing that adds distance but ensures safe separation.

Ad slot (mid)

Return flight: MilanRome

The return flight from Milan to Rome is generally similar in duration to the outbound — typically within 10–20 minutes. Continental routes like this one are less affected by the jet stream asymmetry that makes oceanic east-west routes so uneven. The main variables affecting any difference are: prevailing winds at these latitudes (modest effect), different standard instrument departures/arrivals at each airport (minor effect), and air traffic congestion patterns that vary by time of day and direction.

View MilanRome flight time details

Seasonal variation in flight times

On this short 511-km route, seasonal flight time variation is minimal — typically under 10 minutes. The main seasonal factor is not wind (which has less effect on short flights) but weather-related delays: winter fog, de-icing procedures, and thunderstorm diversions in summer can extend actual gate-to-gate times. FCO and MXP each have their own seasonal delay patterns that affect overall travel time more than en-route conditions.

Airport information

Leonardo da Vinci–Fiumicino Airport (FCO) is a major international hub in Rome, Italy. As a tier-1 airport, it handles high traffic volumes, which means longer average taxi times but also higher flight frequency and competition that can benefit travelers on pricing. Milan Malpensa Airport (MXP) is a major international hub in Milan, Italy. As a tier-1 airport, it handles high traffic volumes, which means longer average taxi times but also higher flight frequency and competition that can benefit travelers on pricing.

Flight times from Rome to other destinations

Flight time FAQ: Rome to Milan

How long is the flight from Rome to Milan?
The estimated gate-to-gate flight time from Rome (FCO) to Milan (MXP) is 1h 11m to 1h 37m, covering a great-circle distance of 511 km (318 mi). This estimate includes taxi, takeoff, cruise at 650–750 km/h, descent, and taxi to the gate.
How is the Rome–Milan flight time calculated?
We use the Haversine formula to compute the great-circle distance between the precise coordinates of FCO and MXP. This 511-km distance is divided by short-haul cruise speed assumptions (650–750 km/h), and 30–50 minutes is added for ground operations and non-cruise phases. The result is a realistic gate-to-gate range, not the airline's scheduled block time.
Is the return flight from Milan to Rome the same duration?
The return flight is usually within 10–20 minutes of the outbound 1h 11m to 1h 37m range. Continental routes are less affected by jet stream asymmetry than oceanic crossings.
What factors make this flight shorter or longer than estimated?
Key variables: (1) Aircraft type — newer jets cruise faster. (2) Wind — modest 10–20 min effect on this continental route. (3) Routing — air traffic may assign paths longer than the great-circle. (4) Airport congestion — taxi times at FCO and MXP vary by time of day. (5) Weather — diversions and holding patterns can add significant time.
Does the Rome–Milan flight time change by season?
Modestly. Seasonal wind pattern shifts can cause 10–20 minutes of variation. Winter weather may add delays from de-icing and reduced visibility, while summer thunderstorms can cause routing diversions. Overall, the seasonal effect on this continental route is relatively small.
Ad slot (bottom)